New 1600kW Caterpillar Diesel Generator






Price (USD): $220,500.00
Item#: USP008926
Wattage: 1,600 kW
Make/Model: Caterpillar 3516B
Year of Mfr: 2011
Fuel Type: Diesel
Frequency: 50 Hz
Additional Info:
Unused 1600kW Diesel Geneset x7sets

Type: Package type
Quantity: 50HZ(6units) / 60HZ(1unit)
 Make: Catapillar 
Year: 2011
Model:3516B
Condition: Unused
1600kW
Volt:6600V
Quantity:7
(Engine)
No. of Cylinders :16
Alignment: V
Cycle:4-Stroke
Cooling Method:Water-cooled
Fuel:Diesel
Speed:1‘500 rpm
Bore:170.00 mm
Stroke:190.00 mm
Displacement:69.00 L
Compression Ratio:14.0:1
Aspiration:Turbo after cooler
Fuel System:Electronic unit injection
Jacket Water heaters:220 V / 9 kW
Starting Motor:24 V / 7 kW
Battery Type:153-5700
(Generator)
Make:Caterpillar
Year:2011
1600kW
Frequency:50HZ
Volt:6600V
Excitation: Permanent Magnet or AREP
Number of Poles:4
Number of Bearings:Single Bearing
Number of Leads:6
Insulation:Class H
IP Rating:IP23
Nominal Speed:1’500 rpm
Over Speed capability:150 %
Wave form Deviation (Line to Line):2 %
Voltage Regulator:3 Phase sensing with selectible volts/Hz
Voltage regulation:Less than ± ½% (steady state) Less than ± 1% (no load to full load)
Telephone Influence Factor (TIF):Less than 50
Total Harmonic Distortion (THD):Less than 5%
 (Dimensions)
Engine: Length x Width x Height:3‘292 x 1‘930 x 1‘511 mm
Weight:7’935 kg
Generator: Length x Width x Height
2’061 x 1’380 x 1’759 mm
Weight:3’945 kg
Radiator: Length x Width x Height
1’900 x 2’588 x 3’051 mm
Dry Weight:884 kg
Complete: Length x Width x Height:
6’264 x 2’588 x 3’051mm
Weight:13’264 kg
 (Technical Data)
Fuel Consumption:
100% load with Fan:412.2 L/hr(Prime)/469.8 L/hr(Standby)
75% load with Fan:311.4 L/hr(Prime)/348.5 L/hr(Standby)
50% load with Fan:218.0 L/hr(Prime)/240.8 L/hr(Standby)
Oil consumption:
75% load:0.247 L/hr(Prime)/0.277 L/hr(Standby)
Cooling System
Engine coolant Capacity with Radiator / expansion Tank
382.0 L:
Engine coolant Capacity:233.0 L
Combustion Air inlet flow rate:122.9 m³/min(Prime)
135.2 m³/min(Standby)
Exhaust stack gas Temperature:517.0 °C(Prime)
538.5 °C(Standby)
Exhaust gas flow rate:339.4 m³/min(Prime)
383.9 m³/min(Standby)
Exhaust System backpressure max.:6.7 kPa
Heat Rejection to coolant (total):674 kW(Prime)/
742 kW(Standby)
Heat Rejection to exhaust (total):1’580 kW(Prime)
1’819 kW(Standby)
Heat Rejection to after cooler:262 kW(Prime)
341 kW(Standby)
Heat Rejection to Atmosphere from Engine:
158 kW(Prime)
166 kW(Standby)
Heat Rejection to Atmosphere from Generator:
68.4 kW(Prime)
80.9 kW(Standby)
Lube System
Sump refill with Filter:401.3 L
Exhaust Emission (Nominal Data); Potential Site Variation possible:
NOx mg/nm³:2’000
CO mg/nm³:125
HC mg/nm³:75
Part Matter mg/nm³:18
 (Radiator)
Radiator Type:44.0 CTD
Design Temperature:38 °C
Radiator coolant Capacity:149.0 L
Air Flow @ 120 Pa:1’543 m³/min
Air Flow @ 180 Pa:1’459 m³/min



Request Quote    Power Calculators


Equipment is sold as is. EXW warehouse. Subject to prior sale. Shipping quotes available upon request.